Viper SL1610SE Uživatelský manuál stáhnout pdf (Strana 6)

6

3) Continually check for foam buildup in

recovery tank. Use a distributor

recommended foam control solution.

NOTE: Excessive foam buildup will not

activate the float shut-off and may cause

damage to the vacuum motor.

4) Repeat extraction path on heavily

soiled areas.

5) If brush stops spinning, there may be

an obstruction in the brush. Unplug the

power cable, raise the brush off the

floor and check for an obstruction.

Check & reset the brush circuit breaker

located on the control housing.

6) When recover of the dirty solution ends,

or the solution tank is empty, you must

drain the recovery tank. (see TANK

DRAINING)

USE OF ACCESSORY TOOLS

NOTE: Prior to cleaning upholstery, be

sure to read cleaning instructions provided

by the manufacturer.

1) Disconnect black vacuum hose off the

back right side of the machine.

Connect (optional) accessory vacuum

hose to area where the standard

vacuum hose was removed.

2) Connect (optional) accessory solution

hose to brass quick connect coupler

located on the back of the machine.

3) Connect (optional) accessory tool to

solution and vacuum hoses.

4) Turn on vacuum / pump switch.

5) Operate accessory tools as needed.

6) When cleaning is completed, relieve

water pressure from solution lines by

turning off vacuum / pump switch and

then squeeze trigger for 4 seconds.

DRAINING TANKS

DRAINING SOLUTION TANK

1) Disconnect vacuum hose from back of

machine and connect the “bleeder”

vacuum hose (included with machine)

to the machine back.

2) Remove the solution tank filter at the

fill area and place end of “bleeder”

hose into the bottom of the tank.

3) Turn on vacuum / pump switch &

vacuum out the remaining solution.

DRAINING RECOVERY TANK

1) Turn off machine, unplug and remove

power cable.

2) Unhook drain hose off the back of the

machine and remove drain hose

stopper.

3) Drain dirty solution into floor drain.

4) Replace drain hose stopper and

reattach hose to back of machine.

MACHINE MAINTENANCE

To keep the machine performing well

for many years, please follow the

following maintenance procedures.

!!! Always confirm that the machine

is unplugged prior to performing

any maintenance or repairs!!!

DAILY MAINTENANCE

1) When cleaning operation is complete

for the day, drain and rinse the

recovery tank thoroughly with clean

water.

2) Remove remaining solution from

solution tank.

3) Remove float shut-off (ping pong ball

in cage) from recovery tank and clean

with water.

1 2 3 4 5 6 7 8 9 10 11 ... 16 17

Komentáře k této Příručce

Žádné komentáře